I was planning on it, but I've since sold it and upgraded.Wow this is awesome!!! Would love to see it in action with a video after overhaul. Are you putting a new motor in?
This is my Oerlikon UB 2, portable boring machine, that is if you have a 2 ton crane on your ceiling. It's like a radial arm drill, boring machine, and mill all in one. 8 spindle speeds from 25-2500, all gear driven with 1.2hp at the lowest speed, so lots of torque. Power down feed in three feed rates, Morse 3 spindle with a drawbar. The head swivels 360 with 3 quick detent locks in vertical down and horizontal. It swivels 360* about the vertical column, raises up and down and the horizontal column slides forward and back.
I've got a 13" travel troyke 2 axis coordinate table I'm going to use for small milling. Some models even had a second T-slot table mounted on the side at 90* to the top one. I've got a 300lb 10" Kurt vise I might use with it too.
Haven't got it running yet, have to figure out how to get the motor out of the back column, think I need to pull the head off to get at whatever is securing it. It's made in Switzerland so I expect it to be pretty complicated inside