View attachment 41571 View attachment 41572 View attachment 41573 View attachment 41574 View attachment 41575 View attachment 41576 View attachment 41577 View attachment 41578 View attachment 41579 View attachment 41580 View attachment 41581
here is a update , i took pics of the toe plates as i used them to show those of you who are interested in them, very simple had results in less than 3 minutes without lifting jeep of the ground.
1 set plate on each front tire
2 run a tape measure from pass side to drive side under the jeep in front of the tires and behind the tires
3 on drivers side support the toe plate with a weighted object if your alone, or have someone hold the plate firmly on the tire. set the tapes in the lower hole on front and rear of the toe plates
4 go back to the pass side and insert the tapes into the lower holes on the toe plates ,( same as the drivers side) and hold slight pressure on the tapes to get rid of any slack in the tapes, take your measurements
5 you will notice the front tape in the pic reads 76 3/8" and the rear tape reads 77 1/4" telling you the toe is in almost a full inch, way to much .. move your tie rod lengths to desired toe and recheck until you get what toe setting your looking for. its a real simple , very quick way to take an accurate measurement of your toe.
Thanks for the update and the pics!