Hello everyone, my family and I recently purchased a 1998 Jeep Wrangler SE, 5spd manual transmission with the 2.5L engine.
Being the numb nut that I am, I was messing around with the glove box and looking to see what the wiring and fuse box looked like underneath. I saw a switch and of course I managed to flip it.
I put the switch back to its original position but when I tried to start the Jeep it wouldn’t crank and an alarm went off. It won’t even go into accessory mode without the alarm going off. There is a red LED in one of the blank spots and a small black button beneath it. There is also a speaker in the engine bay that is the source of that forsaken alarm. Since I set off the alarm, the red LED has been flashing. Before, it was just a solid red.
I have attached images of the switch and LED below, I was wondering if anyone could help me out and get my Jeep up and running again. We’ve only had it for 5 days and I would hate to make it sit for too long because of my own stupidity.
Being the numb nut that I am, I was messing around with the glove box and looking to see what the wiring and fuse box looked like underneath. I saw a switch and of course I managed to flip it.
I put the switch back to its original position but when I tried to start the Jeep it wouldn’t crank and an alarm went off. It won’t even go into accessory mode without the alarm going off. There is a red LED in one of the blank spots and a small black button beneath it. There is also a speaker in the engine bay that is the source of that forsaken alarm. Since I set off the alarm, the red LED has been flashing. Before, it was just a solid red.
I have attached images of the switch and LED below, I was wondering if anyone could help me out and get my Jeep up and running again. We’ve only had it for 5 days and I would hate to make it sit for too long because of my own stupidity.