Part # 1 - Background: Okay folks I need to tap into the knowledge bank here. I'm part way through the build of my TJ and I'm stuck on how to proceed with the rear shocks. The Dana 44 rear is setup with the following:
- H&R 52107 Springs (Netted 1.5" lift)
- Savvy Body Lift
- Currie Rear Track Bar, with Currie re-location bracket
- Savvy Control Arms
- Savvy UA
I cycled the suspension and determined I needed 1" bumpstops, to keep the Currie track bar approximately 1/2" from hitting the bottom of the tub at full stuff.
When checking for shock lengths, measuring eye-to-eye, I came up with:
- 13 1/4" Collapsed
- 17" Ride Height
- 22 3/4" Extended (It's at this point that the spring starts to unseat)
- H&R 52107 Springs (Netted 1.5" lift)
- Savvy Body Lift
- Currie Rear Track Bar, with Currie re-location bracket
- Savvy Control Arms
- Savvy UA
I cycled the suspension and determined I needed 1" bumpstops, to keep the Currie track bar approximately 1/2" from hitting the bottom of the tub at full stuff.
When checking for shock lengths, measuring eye-to-eye, I came up with:
- 13 1/4" Collapsed
- 17" Ride Height
- 22 3/4" Extended (It's at this point that the spring starts to unseat)