Soft top zipper trick

AndyG

Because some other guys are perverts
Original poster
Lifetime Supporting Member
Joined
Jul 30, 2018
Messages
18,902
Location
Alabama
Before you grab the pliers and end up damaging a zipper , try this -

Take a good size zip tie , loop it through the zipper pull and cinch it big enough to get 3 fingers in ... it will give you enough pull to get it zipped , and if it breaks , you need a warmer day or better fit possibly.

If you like it , you can super glue the zip tie in position and trim the excess.

It made a big difference on my Trektop NX rear zippers , which tend to be difficult.
 
I waxxed the zippers. Doesn't help get them connected, but they're a lot easier to pull once you get them started.

One of the instructions I was reading said to keep it unhooked at the bottom until the zippers are already started. Then pull the top down & hook the edge in place.
 
I use a small carabiner I keep stored hanging on the turn signal lever.
 
I also made paracord pulls.

7DA2CBD2-5343-4640-AA2E-D0D72C26B805.webp