Starting without the clutch?

No remote starter and will most likely leave it.

The only reason I noticed was one night I went to turn the Jeep on to test the led turn signals I made and while reaching through twisted a touch too far...
 
Last edited:
It was the clutch interlock switch and this is how they bypassed it.
20190528_164337.webp
 
  • Like
Reactions: Steel City 06
Did the PO have a remote starter installed? Many will bypass the safety switch... Not the best idea, you run the possibility of your jeep driving through the garage if you accidentally left it in gear.
Get Chris to tell you his story on this...epic.
 
  • Like
Reactions: IPerkWVU
I had mine in 4low once in my garage and forgot about the automatic clutch bypass. Immediate reaction was to stand on the brakes, which obviously cannot stop it in gear. I was inches away from disaster once I finally reacted by hitting the clutch. Almost got to test a 1/4" steel bumper against 2x6 framing, 1" plywood and a cinder block wall
 
  • Wow
Reactions: derekmac
Did the PO have a remote starter installed? Many will bypass the safety switch... Not the best idea, you run the possibility of your jeep driving through the garage if you accidentally left it in gear.

15 or so years ago my buddy bought a remote start for his manual Honda Prelude and wanted my help installing it. Told him it was not a good idea, that one day you're going to forget and run something over but he still had to have it.

Took a little over a week, he hit the remote start and thing drove across his lawn into a tree.
 
I've found the starting in gear (1st/R) in 4lo to be very helpful a few times.

When the clutch linkage went out on my CJ5, I was still able to drive home, by killing the vehicle at stoplights while in gear, and then starting in gear. If there had been a clutch interlock, I would have had to fix on the road or get towed home.
 
  • Like
Reactions: IPerkWVU
15 or so years ago my buddy bought a remote start for his manual Honda Prelude and wanted my help installing it. Told him it was not a good idea, that one day you're going to forget and run something over but he still had to have it.

Took a little over a week, he hit the remote start and thing drove across his lawn into a tree.
He should have bought a good one. Mine wouldn't arm for remote start unless the clutch was out and parking brake on when the engine was shut off. 7 yrs, no problems until a valet broke the remote. We were staying at a hotel downtown and valet was the only option. It did work for a year or two after that (with me repairing it a couple times), but he mashed the button in, damaging the board.
 
I finally got home and had time to check...
Mine is an '06 and will not start in 4lo, without the clutch pressed in.
 
Rubicon only

The 06 non-rubicons have a fuse in the engine bay box. It disables the clutch interlock and raises the idle.


You can bypass the clutch switch(cut/solder the wires together) on the 06 with no ill effects. Cruise/etc still work properly.
 
Last edited:
Rubicon only

The 06 non-rubicons have a fuse in the engine bay box. It disables the clutch interlock and raises the idle.


You can bypass the clutch on the 06 with no ill effects. Cruise/etc still work properly.
Except...
When I use the fuse, my 4wd light comes on too (some kind of reminder thingey?).
 
Correct.
The wiring diagram for that circuit in the FSM is wrong too. It shows that fuse shorting the clutch switch.

If the battery gets drained too low, it will revert to non-override, even with the fuse in.