I purchased a 2003 Rubicon with about 4.5" of lift installed. From what I can tell it looks like a stock rear driveshaft. The driveshaft looks like it is at a very steep angle. So in general I know that once you hit 4" of lift it is usually best to install a slip yoke eliminator. Of course the Rubicon has the np241 transfer case. I have not been able to locate a sye for this transfer case. Do I need one? / do they make one? Or do I just need a CV drive shaft like this?
https://www.quadratec.com/products/...AOlevQ60dqbsJ2r9bOe_CnTL65bavnvhoC2-QQAvD_BwE
Also would this one be a good one to purchase? Any other ideas of what I should get?
Thanks for any help
https://www.quadratec.com/products/...AOlevQ60dqbsJ2r9bOe_CnTL65bavnvhoC2-QQAvD_BwE
Also would this one be a good one to purchase? Any other ideas of what I should get?
Thanks for any help