Recent content by lindsey97

  1. L

    SOLD: Warn Bumpers and tire carrier

    That is too cheap!!!
  2. L

    SOLD Sony MEX-N5200BT radio for sale

    I'll take it. PM me your paypal address and I will get you paid. Shipping will be to 73098.
  3. L

    ARB twin compressor project questions

    A lot of power. Power supply cost would probably exceed cost of compressor. Get a pelican case from the gun store, and a cheap set of jumper cables. Cut the ends off of one end, and hard wire them in. You can also make an air tank out of a 30 lb. Freon cylinder or something similar.
  4. L

    Yellowbox Speedo Controller Not Working

    Blue monkey was a snap to install, and once you got the hang of setting it, it wasn't bad at all. I mounted mine inside the cab, away from engine heat and elements. Do they have a watch battery in them or something?
  5. L

    Homebrew Tube Doors (Another Low Dough Build)

    I'm glad the hinges worked out for you. I thought they would, and I ran them on mine with the Jeep bushings, with no slack or rattles. You're welcome!!
  6. L

    Oil Pressure Gauge Very Low on Start-up

    Could be having ground issues. Clean your battery terminals, check your cable ends where they connect to the frame or engine, and make sure the body has a good ground connection to the frame and motor.
  7. L

    I want to buy this Jeep but I need your help

    I found a '97 Wrangler SE, red, soft top, with AC for $3800.00 150k miles. OKC facebook marketplace. The yellow Jeep in question had BDS on the right rear shock. Maybe BDS suspension? It's a little high. $4500 would definitely buy it anywhere else. The prices are coming down across the...
  8. L

    How long before I trash my tailgate hinges?

    Rubicons come from the factory with 31" tires, I would like to think you will be fine. Just don't let the tire wobble on the carrier.
  9. L

    How do you store your rear seats?

    In a van down by the river.
  10. L

    Do all Jeep Wrangler TJ have side step OEM mounting holes?

    Just bought a set of these, and was suspecting that nutserts are used to mount them. I would be installing a 4 hole set, to a 2005. I'm assuming this will work. Would anyone be kind enough to tell me what size the nutserts and bolts are? Maybe a tool used to install them?
  11. L

    Is there anywhere I can just by the rear portion of the center console?

    What part are you needing? The white part on the inside of the console? We have one that we cut the cupholders off of for a tuffy installation, pay the shipping and it's yours. Our lid is also split and broke in the middle, which is why it got replaced with the tuffy. I also recommend...
  12. L

    Homebrew Tube Doors (Another Low Dough Build)

    If you are interested, I have a set of hinges. They have the wrong diameter pins. What happened was smittybilt shipped me a set of xrc tube tj doors, and they sent JK hinges. TJ door pins are 0.365"-0.370" diameter. Jk are 0.430" So I took the Tj bushings out and drove like that for a...
  13. L

    Should I pull the trigger on this LJ Rubicon?

    The undercarriage appears as new. Looks to have been garage kept.
  14. L

    Should I pull the trigger on this LJ Rubicon?

    The plusses I see are: Rubicon lockers, warn winch, rear warn swing out tire carrier, front ARB bumper, and hardtop that is an LJ hardtop. What I mentioned in parts is $5k and you didn't have to install it. Run a fluid sample on the oil, go test drive it, and inspect the insides of the frame...