ac compressor

  1. juaneslh

    A/C Issue on a 2004 TJ

    Hey Ya’ll, First post on here but i’m hoping to get some advice about what may be going on with my tj. I bought a 2004 2.4L with 132k miles a month ago and it has AC but it hasn’t blown cold. I decided to recharge it with some freon but when I recharged it the gauge was going up and down and...
  2. S

    A/C pressure levels

    AC compressor clutch is not spinning. I forced it with a paper clip and just put in some refrigerant. I’m showing 30 low and 175 high. It’s about 60 degrees here. Does anyone know what the level should be at? I changed out the fuse and relay but compressor clutch still not spinning without...
  3. kindagonzo

    Can anyone help me identify this noise?

    I just had my cylinder head replaced on my 2000 2.5L. As I drove home, the noise started. It takes a few minutes to wind up and I noticed that the "whirring" noise changes pitch when the compressor is engaged. https://photos.app.goo.gl/4giA4Y6ouae8Bn1Z8 Does anyone know where I should start...
  4. jwmays.81

    AC compressor questions/on passenger side??

    Hey guys and gals! First time poster and new to the TJ world. I bought my 2000 TJ knowing that the AC didn't work, but I'm now trying to see what all needs to be done to get it working properly. The puzzling thing is that is appears that the AC compressor is mounted in a completely different...
  5. 99saharajeep

    Ac system

    I'm 17 trying to make a good daily driver that's fun and reliable, I have a 2002 tj that has a rusted frame, I found this out a few months after replacing the blown engine with a low milage engine and trans that I bought from bruiser conversions. I will be using it for parts to complete my new...
  6. Jrc4055

    Is my power steering pump leaking?

    Hey all, I spent my weekend replacing what I thought was a leaky AC compressor. Well...The leak is still there, and I need your help finding the culprit. I'm wondering if its the Power Steering Pump for a couple reasons: 1. There is oil pooling on the top of the AC compressor and dripping down...
  7. oscaralexander

    Gas gauge not working soon after starting; A/C blower not working

    Hey, I replaced my PCM in order to resolve limp mode issues with my TCM and was hoping it would fix my gas gauge issue but it has not. My gas gauge will read normally on start but after a couple minutes driving it will read empty with the gas light. I have already tried replacing the...
  8. Notch8022

    Jeep TJ A/C reinstall

    Folks, I have a 2000 Jeep tj. I am looking to put ac back in it. I have bought all new components for the engine bay. Compressor, condensate coil, ac lines, evap dryer. I am trying to locate the plug in for the compressor. I had a new motor installed in the jeep, there are 2 plugs that are not...
  9. B

    AC Hoses don't fit into compressor

    I'm a bit stumped. I replaced my AC compressor about a year ago after the original one failed, as well as my AC/refrigerant hoses, and I'm just now getting around to making a post about the issue I've run int...😅 my problem is that the hoses are not fitting flush into the AC compressor. I...
  10. F

    AC Compressor Oil Reference

    All, I had a hard time finding this when repairing my AC system, so thought I would share attached. Denso Compressor Oil Chart My 2000 TJ 4.0 took a Denso 471-0400 10PA17E I hope it helps. /r Brad
  11. Michael Roberson

    Air Conditioning Compressor not Engaging

    Someone please point me to the best thread for diagnosing air conditioning problems. Symptoms are as follows: yesterday it worked perfectly. This morning I turned it on and it seems like the compressor isn't engaging. It's blowing but there is no cold air. The switches seem to be working...
  12. Chander

    AC lines are hot and not getting R134a

    please help ! i just install the whole system in my TJ98 4.0 ! My was no ac from factory ! I install the whole system everything look good ! No leaks ... the compressor start! But for some reasons after the vacumm , when i go to add the R134a the lines get hot the psi raise to 90 ! And the can...