bushing

  1. F

    Reconnecting stabilizer bar to frame

    I recently bought a 2000 TJ that had one bolt and some terrible welds holding each of the stabilizer bar retainers to the frame. I’m ready to reattach the stabilizer bar and looking for input on the best way to bolt the retainers to the frame. I had to remove the welded nuts on the inside of the...
  2. S

    Automatic shifter issues (not related to the broken bushing)

    Having an issue similar to the broken bushing. However, after inspection the bushing that connects the cable to the shifter is fine and still connected… However, the car will not shift out of park probably. But I can go under the car and push the mechanism and it can go into drive (emergency...
  3. M

    Rear differential problem or other?

    Hey Jeepers. 2005 Rubicon TJ, Auto w/ 152k. Here is my issue: Lately I've been feeling a loud clunk when turning namely left. Well it's more of a snap feeling and sound. So. The other day I was driving home and the "rear lock" light began flashing on the dash. I pulled over and this stopped...
  4. Mcnenc1

    Death wobble to small wobble?

    I know this question had been beaten too many times but I’m having trouble and can not find a solid answer... Going 70mph in sunny hot Florida I hit a pot hole and experienced full on death wobble. Cool. The same day I ordered a new track bar, steering stabilizer, tie rod, and drag link...
  5. AZ2CO98tj

    How to press out upper control arm bushing?

    as the title states. what is the best/ easiest way you gurus have found to press out the old upper control arm bushing on top of the differential (driver side). i have tried PB blaster and heat combined with a ball joint press but no dice! figured i might as well put a new one in since im...
  6. 1Blacktj

    Automatic trans shifter bushing

    So yesterday my transmission bushing went out so I did some research and found Best4x4 mod over on wranglerforum. As of right now I have the nylon spacers on the outside but I am trying to find a nylon spacer or bushing of some sort to go in the shifter linkage. Does anyone know the size of...
  7. weldedcambolt

    Question about pressing in control arm bushings

    Question that always baffles the dyslexcia............going to press in a bushing upper front. froze it to get it smaller. now, the metal hole that the control arm bushing goes into, is outside an probably at the same temp as the freezer, so that hole got smaller, also, or did it get larger...