Ive gotten a bit more relaxed with my gear. Standard tool set with an impact. a small box with a ujoint or two, couple ratchet straps and tree strap. Then a cooler with water and snacks
Can you hit me with the TJ specific list? I just bought a 36mm and a couple 13mm 12-point sockets.
I have the glue tread and I tried to use it once. The slice was at the same location as a slightly raised letter on the sidewall and the sandpaper that they provide is good enough to scuff up the tire but not remove enough material to sand down a letter or anything that may be sticking out. Without having a flat surface it does not seal good. For me it did slow the leak down and allow me to get back to the parking lot with adding air every mile or so. I have had much better luck with just using multiple tire plugs. It would probably work if the slice was in a location where there was no raised letters, etc...
I did start carrying my cordless drill and a tire grinding head so that I could use that to make a flat surface in the future. I may purchase these slugs and throw them in the box. Also, not sure if it was mentioned somewhere, but Colby Valves are also a must have with you on the trail. I ripped off a valve stem during my last outing and within 5 minutes had colby valve installed and aired up.
Any new thoughts on glue tread?