Re-gear pricing?

[Chris]

I paid $1000 for my re-gear, that was with me supplying the gears and master overhaul kit.

So if you add what I paid for gears, it comes out to around $1650 total.

 

[dla]

My re-gear ran me a bit over $1,800 but that included a Detroit Truetrac and Yukon alloy shafts in the rear (labor was $700 of that).

 

[Serbonze]

I paid $750 for labor, which included front and back. I supplied the Revolution gears that I purchased from AOR that were around $420.

 

[makorider]

https://www.revolutiongear.com/rem_surface_finishing which eliminates the need for the usual lengthy gear break-in process, makes them run cooler and last longer. $60 per R&P gearset.

Family busines was metal finishing.

$60 bucks for a wet vibe in ceramic media???? Jesus why didn't I think of that? Crazy expensive for what it is.

 

[Fouledplugs]

Local reputable crawler shop here in Alabama charges 250 per axle for labor.

 

[Rocky Wrangler]

I put Yukon 5:13 in my LJ and the gears cost $1150 with lifetime warranty on the parts and $800 for the install. I ordered the parts from Randy's Ring and Pinion. That was with the master rebuild kit for each axle as well.

About $2,000 all in.

 

[chandler.99tj]

Local reputable crawler shop here in Alabama charges 250 per axle for labor.

What shop in Alabama? I’m trying to get quotes to regear mine right now. The cheapest I’ve found is around $1000 labor

 

[BC Moto]

Thats not bad

 

[chandler.99tj]

I’d still rather find cheaper if I could. Right now that puts me at around $2100 for 5.13s and a spartan locker for the front

 

[SoCalGlide]

If you're near Ventura, CA, I highly recommend the shop that did my gears a few weeks ago. $1670 OTD. The shop supplied the Revolution 5.13 gears, and installation kit. This also included installing the Torq Locker I supplied, and new axle bearings and seals on the rear axles. Coastal Differential Repair, 805-654-8080, Marty is the owner's name.

 

[chudlet]

@chandler.99tj Just remember you are replying to a thread that was 4 years old already. Prices may have changed since then ;-)

 

[chandler.99tj]

@chandler.99tj Just remember you are replying to a thread that was 4 years old already. Prices may have changed since then ;-)

Yeah I figured I would be paying more. Especially with how tanked our economy is right now. I’m just hoping to find somewhere a little cheaper in Alabama if possible

 

[R3ID05TJ]

What shop in Alabama? I’m trying to get quotes to regear mine right now. The cheapest I’ve found is around $1000 labor

That was in 2018

 

[Fouledplugs]

Yeah I figured I would be paying more. Especially with how tanked our economy is right now. I’m just hoping to find somewhere a little cheaper in Alabama if possible

Yea go see Keith at Off Road Connection in Fultondale