I installed the tailgate prop I made using @jscherb 's design (thanks for the plans, Jeff!):
Instead of bending the wire, I cut four pieces, fusion-welded them with my TIG torch, and then cut the center out of the side that mounts in the bracket on the outer hinge. Worked good!
I also installed @Blackjack 's winch snorkel bolt, but, unfortunately, I took no pictures. I ran the tubing up to a Parker Fast & Tite 90° fitting in the top of the airbox. I also put RTV on the gearbox side of the motor housing, as it didn't have any.
Instead of bending the wire, I cut four pieces, fusion-welded them with my TIG torch, and then cut the center out of the side that mounts in the bracket on the outer hinge. Worked good!
I also installed @Blackjack 's winch snorkel bolt, but, unfortunately, I took no pictures. I ran the tubing up to a Parker Fast & Tite 90° fitting in the top of the airbox. I also put RTV on the gearbox side of the motor housing, as it didn't have any.
Last edited: