MountaineerTom
LJ Enthusiast, Retired USAF Weapons Loader
Supporting Member
Ride of the Month Winner
Installed a JBL Basspro Nano subwoofer under the driver's side fold and tumble seat. In the past I has some one-inch seat risers under the seat but I took them off because my wife has mobility issues, and it was getting hard for her to get in the Jeep. I put the drivers side seat lift back in since she rarely drivers it. The one-inch risers are required with the fold and tumble seat. That bar that runs across it was just barely touching it with the sub just laying in there to see if it would fit. It may have had more clearance once the unit was secured to the floor but I wanted to make sure so I just put the seat lift back in. It's a very close fit width wise between the seat rails. The floor drops down a little towards the rear, so I added a couple nylon spacers to level it out a little more.
Happy with it so far. This is the first sub I've owned so I need to figure out how to play with the settings.
The dimensions per the owner's manual:
10-1/4" long
7-11/16" wide
2-15/16" high
Seat tilted/folded forward.
Seat in the back, driving position.
Remote control on the bottom edge of the dash.
Happy with it so far. This is the first sub I've owned so I need to figure out how to play with the settings.
The dimensions per the owner's manual:
10-1/4" long
7-11/16" wide
2-15/16" high
Seat tilted/folded forward.
Seat in the back, driving position.
Remote control on the bottom edge of the dash.