Replaced brake master cylinder and slave cylinders (drum). Bled master and lines and cleaned everything with brake cleaner. Still a bit of trapped air....or maybe brake rubber lines need replacing [emoji848]
Sent from my iPhone using Tapatalk
Installed LED’s on the TJ
Parking light mod: changed from Amber turn signal to red US spec.
.......3rd edit:
Had to modify LED Brake light assembly to turn on at half brightness with rheostat (324 Ohms) for ‘parking lights’ ; the LED brake light becomes brake (Full bright) + park light (1/2...
Just did this a couple days ago - bit fiddly but well within the DIY scope of most. Bought this tool : It’s a pilot bearing puller - worked well although I had to get creative when I ran outta threads pulling that stupid bearing outta the case.
Ended up with spare parts in the quadratech...
Took the NP231 out for rebuild, replaced rear sway bar link bushes with poly bushes, cut a hole in the frame to be able to remove the transfer case belly pan cos the nut on the inside decided to free-wheel [emoji849] - put stainless bolts in front warn bumper, removed the exhaust system to...
The yellow covered ‘big’ port to the far right is your low pressure port - you using a manifold gauge or a cheapie recharge kit? If you are using a short hose to recharge, be careful not to hydrolock the compressor by adding as a liquid (keep bottle upright when running compressor)
Sent from...
Not really for the tj (Sold it to my neighbour) but I knew you guys might appreciate it
Recycled front pads and inner bearing race
Bevelled
Tacked
Finished up the welding
3 x the threads
Outer races as a spacer
Tada!!
Sent from my iPhone using Tapatalk
Had a few capacitors for my TV that I ordered off ebay - bought low esr ones.
Google 2200uf panasonic
Panasonic FM 2200uf 16V, Low-ESR, Electrolytic Capacitor, Radial Lead, 7000 Hours @ 105C, 20% Tolerance, (12.5 x 25mm) L x Dia. (Pack of 6)...
2200uF in the jeep with the diode gives about 6 seconds of on time after the circuit is interrupted so works just fine with the TJ setup. I also wired up a pushbutton start because my ignition switch is faulty and havent ordered a new one yet - this was when I noticed what you said about the...
Installed a 2200 uF Electrolytic capacitor and diode in to the switched acc line just prior to the Pioneer stereo headunit to keep my bluetooth connection alive during key switch movement
Sent from my iPhone using Tapatalk
Hey man - did you evacuate the system using a vacuum pump before recharging it? Was the accumulator/dryer also replaced? Thirdly, how much oil did you put in?
Common mistake when installing a new compressor is adding too much oil - the new compressor may have come preloaded with a full charge...
Nice work - did you design the arm pivot assembly or did you buy with a kit? Was just thinking about doing this the other day...
Sent from my iPhone using Tapatalk