clutch change

I replaced the flywheel, clutch, pilot bearing, throwout bearing, master and slave cylinders in my 2001 Wrangler. Replacement seemed to go fine. I had no difficulties. The cylinders came assembled as an all in one unit and supposedly doesn’t require bleeding. Pedal feels fine- firm but not...

Hey all, I'm driving an 06 LJ (6speed manual 4.0L engine). No lift or any mods on the car, it's my daily drive. My clutch was almost entirely out, so just got it replaced. I used the LUK clutch kit off of rock auto based on positive reviews. Right after picking it up, I noticed that it...

I have an 05 unlimited wrangler with a 4.0 standard 6 speed. It was neglected by my parents and i have been restoring it. Between the lack of a garage and 16 years worth of rust built up on it, i have been having a garage do the work after i get the parts unless the bolts don't seem to bad (good...

I have a 1998 2.5l with the ax-5 manual tranny. SHORT VERSION AT THE BOTTOM So on the 11th of June after not driving my TJ for a week or two and not noticing any problems when I parked it last, I went to start it and drive off after oil started flowing. It went into 1st just fine no resistance...

Hello all, so my clutch in my 2004 4.0l decided to die on me the other day conveniently the day after I got a new clutch because I knew it was coming. So I disconnected everything yet the trans doesn't seem to want to come off. We tried evening out the engine with the trans with lifts on both...

Hey guys my clutch is starting to go. I was wondering if there were any good brands I should go with, my jeep does have slightly bigger tires on it. Also I wanted to know if anyone has used a south bend or had any opinions in it. Also if there were any tips for doing it yourself to make it...

So I’ve had this problem going on for a while but it’s been off and on. I have 1998 2.5 liter with 72000 miles and the clutch is making a growling noise when idling. When I engage the clutch it goes quite but is still slightly there. It doesn’t have any problems changing gears but the noise it...

Does anyone know what the retainer wire for the clutch fork and throw out bearing is called? and how to get one. It's the wire/retainer/spring that holds the fork and the TOB in place on a 4.0L Manual.

So I'm going to be replacing my clutch in the next couple weeks and plan to address an oil leak (possible RMS?) while its apart. I was wondering if there is anything else I should look into or replace/repair while I'm at it? My goal is to steadily "restore and strengthen" each system with the...

Hey fellow jeep owners! i'm new to the forum so bare with me! I Just have some questions regarding my jeep and some issues I came across. Any help/Advice is very much appreciated. 2000 Jeep Sahara TJ 4.0 I6 Issue # ONE: my clutch {recently} completely gave out/fried. I am currently...