I ordered some short 1/4-28 nylon set screws in June. They got here two days ago. Now if the laser shop would finish up some stuff I ordered months ago, we could start shipping them.
One thing I've noticed over the years is lots of folks converted to LED tail lights by drilling a 4" hole for the round versions. Then they are reluctant to go back to any other style because there are no mounting holes left in the tub. I made that a trifle easier by adding 4 mounting holes, one in each corner.
View attachment 471177
The hole in the back was laid out by making a template of the stock TJ tub, tracing around it from the inside and then handing that template to the machinist.
View attachment 471178
The marker lights are held in with nylon set screws mentioned above. The lights are directional up and down in order to get them to properly create the extra wide viewing angle so I needed an easy way to adjust them and line them all up.
View attachment 471179
Will these be plug and play or will plugs need to be wired in?