Ordered two sets of US Jacks 6-ton jack stands to get the Jeep up on all 4 corners on USA-made jack stands and off the generic 6-tons that have the front off the ground.
Ground back to clean metal and plug is ready to weld inAddressing some minor rust issues behind drivers seat where the roll bar mounts
View attachment 232494
View attachment 232495
View attachment 232496
Where is that from? I remember that.Thanks, I like the “daktari “ look.
I barely remember it, it was some show set in Africa something about safaris or a game preserve or somethingWhere is that from? I remember that.
I barely remember it, it was some show set in Africa something about safaris or a game preserve or something
I mainly remember the land rovers.
Is your Jeep dead?Replaced factory speakers with kicker cs series 2 ways. Actually have pod speakers now which is nice, can hear the music for once. Next stop sub and amp but they are coming via delivery! Went for a sunset cruise through Brisbane with the roof off too. So nice!
View attachment 232614
View attachment 232616
Left it at the shop while we head west for Vacation. Doing an entire suspension overhaul, I sure wish I had the time, patience, and skill to tackle it myself.
View attachment 232385
I hate to do this here but I'm not getting much action where I posted this question... It isn't "What" I did to the TJ, but what I'm "going to do". Looking for a little guidance if you all don't mind...
I have an 05 Sport, 4.0 with the dreaded RLE 4 speed auto trans. I have the Dana 44 with a 3.73 gear. This is my daily driver and 98% of the time, I will driving on paved roads and the remaining 2% will be dirt roads, and rarely if ever, off road. Our roads are pretty flat here in metro Detroit so I'm not driving in hilly areas at all really which helps with the 3.73 and an increased tire size. I have the 2" Pro Comp springs and shock lift so I know I'm not going any larger than 33's and I am convinced that I will go with 32's before I would even consider 33's because everything I've read on this forum has me scared $h!tless to go with 33's because of my 3.73. I understand that I can turn my overdrive off to help with that but I do occasionally drive on the highway and I would still like to after I get new tires so that's another reason why I don't want 33's. Unless I can be convinced that I am over-reacting.
I am super bummed because I was so ready to buy the Mickey Thompson ATZ P3's in the 32" but I just learned that they phased them out over the winter. Maybe sooner but they were available in October when I started my search. So plan B is probably going to be the BFG KO2's even though I don't think they are anywhere as nice looking as the ATZ's and the Cooper SST's are so expensive. Which brings me to another thing. Good news email today, I receive Mopar emails because I'm signed up for monthly email maintenance reminders for my Ram and I also get promotional emails of course but, back by popular demand, they have their annual buy 3 tires and get 1 for a $1 so what better time to buy!
As for wheels, please help me understand a little more about these as well. Going with the larger and wider tires I know I may have issues with rubbing so I want to avoid that. I will be getting 15x8 wheels and I think I need to select a wheel with something closer to a 3.75" backspace to avoid the tires from rubbing at full turn?? Am I on the right track as far as backspacing goes? I am looking to widen my stance some and I think the 3.75 BS will accomplish that while at the same time, clear me from any possibility of rubbing....hopefully, right? One more thing, does an offset matter for function or is that mainly for looks?
Original post location:
https://wranglertjforum.com/threads/help-with-wheel-and-tire-decision.47596/
Thank you to anyone that can help!
Yeah, I've been scouring the web for them with no luck. I think the problem is the tire isn't stocked normally anywhere and the tire shops order from their distributors which just aren't getting them from MT. I've looked and looked. Believe me though, I will look until I buy and hope they turn up. I just need to make sure that I'm getting the right size first. I can find them all day in 33's.For the tires have you looked around at not so obvious places for the MT's ?? Amazon Ebay just google search and scroll for days, I have had some good luck in the past doing this.
I hope that you size combo will work because that is what I plan on running after I get my lift, 15x8 Methods with 3.5 backspacing and -24mm offset going to run 33x12.50
Have them swap out that K&N filter while it's there.Left it at the shop while we head west for Vacation. Doing an entire suspension overhaul, I sure wish I had the time, patience, and skill to tackle it myself.
View attachment 232385
Offset and backspacing are the same measurement from different directions. Forget about offset, you only care about backspacing and 3.75-4" is what you're after.I hate to do this here but I'm not getting much action where I posted this question... It isn't "What" I did to the TJ, but what I'm "going to do". Looking for a little guidance if you all don't mind...
I have an 05 Sport, 4.0 with the dreaded RLE 4 speed auto trans. I have the Dana 44 with a 3.73 gear. This is my daily driver and 98% of the time, I will driving on paved roads and the remaining 2% will be dirt roads, and rarely if ever, off road. Our roads are pretty flat here in metro Detroit so I'm not driving in hilly areas at all really which helps with the 3.73 and an increased tire size. I have the 2" Pro Comp springs and shock lift so I know I'm not going any larger than 33's and I am convinced that I will go with 32's before I would even consider 33's because everything I've read on this forum has me scared $h!tless to go with 33's because of my 3.73. I understand that I can turn my overdrive off to help with that but I do occasionally drive on the highway and I would still like to after I get new tires so that's another reason why I don't want 33's. Unless I can be convinced that I am over-reacting.
I am super bummed because I was so ready to buy the Mickey Thompson ATZ P3's in the 32" but I just learned that they phased them out over the winter. Maybe sooner but they were available in October when I started my search. So plan B is probably going to be the BFG KO2's even though I don't think they are anywhere as nice looking as the ATZ's and the Cooper SST's are so expensive. Which brings me to another thing. Good news email today, I receive Mopar emails because I'm signed up for monthly email maintenance reminders for my Ram and I also get promotional emails of course but, back by popular demand, they have their annual buy 3 tires and get 1 for a $1 so what better time to buy!
As for wheels, please help me understand a little more about these as well. Going with the larger and wider tires I know I may have issues with rubbing so I want to avoid that. I will be getting 15x8 wheels and I think I need to select a wheel with something closer to a 3.75" backspace to avoid the tires from rubbing at full turn?? Am I on the right track as far as backspacing goes? I am looking to widen my stance some and I think the 3.75 BS will accomplish that while at the same time, clear me from any possibility of rubbing....hopefully, right? One more thing, does an offset matter for function or is that mainly for looks?
Original post location:
https://wranglertjforum.com/threads/help-with-wheel-and-tire-decision.47596/
Thank you to anyone that can help!