Assume I can figure it out but as I have minimal (read as no) fabrication skills hope you don’t mind a couple questions. Thankfully I have a younger brother who has such skills so questions really are to make easier for him when I say please install this.
First question to make clear my lack of mechanical knowledge. What is that tray for?
Did you mount the compressor to the supports for the tray or remove middle of tray to allow air flow, mount compressor to tray, and then mount tray back to stock holes?
Did you put any type of isolator between compressor and where mounted? I’ve seen it mentioned but not sure if is enough vibration to make necessary?
For the filters and manifold is it just let Jeep/space tell you how to create the bracket?