When it has rained 4" in the last week, the trailer is in the backyard, you have a 2wd pickup, but you're going wheeling this weekend. You come up with solutions
When it has rained 4" in the last week, the trailer is in the backyard, you have a 2wd pickup, but you're going wheeling this weekend. You come up with solutions
View attachment 384126
Added Seat Heaters to the PRP daily drivers. It was super easy, only had to untie the lace, remove one staple, pull up cover, install pads, and reassemble. Took me longer to get the peal covering off the sticky part of the pad then it did to disassemble and reassemble the seat.
Dorman 628-040 universal kit installed on both driver and passenger side.
View attachment 384510
Added Seat Heaters to the PRP daily drivers. It was super easy, only had to untie the lace, remove one staple, pull up cover, install pads, and reassemble. Took me longer to get the peal covering off the sticky part of the pad then it did to disassemble and reassemble the seat.
Dorman 628-040 universal kit installed on both driver and passenger side.
View attachment 384510
That’s good to know. I already have the Dorman heaters so I won’t order the PRPs with seat heaters.
Front Locker troubleshooting resulted in a bad connector at the diff connection which was a disappointment because if I would have went with my gut feeling and just cut out the connector on the side of the trail I would have had a locker. But while I was fixing it (cut out connector and soldering wires directly together), I lost the ground somewhere, so further troubleshooting resulted in ziptie pinching and breaking the wire. So the wire would have most likely broke along side of the trail which would have had me back to no locker. Guess I was just meant to wheel with no front locker so I can understand how the other half lives!!
The pile after troubleshooting:
View attachment 385628
The connector on the relay side was good and had power and ground to it on the side of the trail. The connector on the locker side had an internal short and I don't understand why the fuse didn't blow.
Ground wire damage, you can see the marking from the zip tie.
View attachment 385629
I didn't have great success with that connector either and ended up replacing it with bullet connectors and heat shrink over top. It seems to be somewhat common.