transmission

Can anyone tell me if the transmission side of the bell housing is the same between the NV3550 and the AX15? Are the bell housings able to be swapped between the two?

Hello everyone, I have been a TJ owner for 6 years now and have used this forum countless times but this is my first time posting. I will be adding a hayden 526 trans cooler soon in series with my factory cooler. Does anyone know what the ID is of the short piece of soft line is that connects...

I bought my 2006 Jeep LJ from a buddy not too long ago and he has it straight piped. After a couple of months of daily driving the droning got to me. Found a 40 series Flowmaster muffler on Facebook and bought it. Cut a piece out of the pipe, used some adapters and now it was bearable....... I...

My apologies as I know somewhere on here I asked this question on a thread but I can't find where it is, hence this thread. 2004 LJ automatic. I have Dana 44s front and rear with 4.88 gears and I am running 33s x12.5 on 15" rims I was told DON'T go to 35s unless I go to 5.38 gears because of...

Hi all, I recently purchased a 99 Wrangler and have been having the best time with it. My question is pretty general, please help so i know which direction to go. My Jeep has a set of 285 70 R17 tires that the previous owner has installed with a 4 in lift, plenty of tread left on it. Being a...

Hi Guys, Followed this forum for a while, but first post. Warning - long post ahead. A bit of history about my Jeep. I bought my 97 wrangler sahara 4.0 auto in November 2018. It was being sold after being parked for two years due to erratic shifting. While looking it over I discovered the TV...

Everything was going fine today until I was rolling to a red light in neutral at about 40 mph and the light turned green. I popped it into 4th gear and wham this extremely loud grinding sound. I pull my jeep over and then I try to put it into 1st to move and there is the grinding again. Had to...

Hello everyone, First I would like to say, im new to posting to this forum but I have read as much as I can on here. So I am also newer to Jeeps as well. Long story short I ended up with a 2004 LJ with about 122k miles on. The guy I bought it from (also I had no clue) did a horrible job with...

I have a 2004 Jeep Wrangler LJ with 148K Miles. I am doing an LS Swap and have pulled the Factory 4.0 and 42RLE. I also have the factory Dana 44 Rear End and Dana 30 Front End. I will detail the parts below. All parts also fit a TJ 4.0 Engine I bought it and wanted to go through the engine to...

I have taken my Jeep to multiple mechanics and have been told multiple possible scenarios. However, no one has found the true issue. Story goes as this... I’m driving down the road and shift into 5th gear, at about 55+ a flutter noise begins. It continues even when the clutch is depressed. The...

I'm new to owning a LJ (just over a week now) and already modifying it :) I will be taking it off road very soon and the trails have some rock climbing spots, anywhere from easy to "no way am I going there in this Jeep". I have the following... 2" OME lift 1.25" JKS body lift 1" motor mount...

Hello all, That title wasn't phrased very well, but in essence I'm trying to figure out what part(s) I need to replace for my leaking transmission oil system. The leak is happening right at the side of the oil tank below the radiator. This is the only picture I have on hand right now: It's...

My PCM is showing P0106. That means that the next issue is with my 42LE transmission shifting. No new are available from MOPAR until estimated 12/31/2018. When ever I am told end of the year I get nervous. Also that costs 999.99. Ouch. Looked for a rebuilt. Nope none available. Finally...

As the title says, I've got a weird rattle (but no shake) when letting off the gas while im in gear, this only happens under about 30 mph and 2end gear. Also on a side note my reverse gear doesn't seem to want to "click" in sometimes and it just ends up grinding unless I push it in id...

Hey I am new to the whole forum thing and to be honest I usually avoid them like the plague but I have come to a crossroads and don't have anywhere else to turn. That being said I apologize ahead of time if I lose anyone in all this. I am wanting to learn more about engines, transmissions and...

Just got word that I have to or highly recommended that I replacement trans. Just seeing if anyone has done this with an after market, rebuild or and did you go with an OEM? Recommendations always welcome.

Well, after hard shifting and re-setting via battery weekly, and some nice codes... P1604 - PCM Internal Dual-Port Ram Read/Write Integrity Faiilure P0700 - Transmission Control System P0613 - Internal TCM I took my old PCM and took a trip to the local NAPA store. They sent it off the be...

Just bought a 02 Sahara 4.0 for stupid cheap. CEL was on and PO stated it was for Torque Converter Lockup solenoid???? I know it's a 3 spd and it shifts great. However the torque converter doesn't lockup at highway speeds, at 55mph it's around 2100 rpms. My question is: If change out the switch...

I have a 2006 Unlimited with a automatic trans that has started to shift hard from 1st gear into 2nd. It happens when the jeep is typically cold and it only happens once. I checked the transmission fluid and it was very low at normal operating temps and didn't register on the dipstick. I slowly...

So yesterday my transmission bushing went out so I did some research and found Best4x4 mod over on wranglerforum. As of right now I have the nylon spacers on the outside but I am trying to find a nylon spacer or bushing of some sort to go in the shifter linkage. Does anyone know the size of...