help

can anyone help me find out if its hard to take the stripped bolt put 2000 jeep 4.0 l. If I have to get it done does anyone else know how much it'll be? Its the tip screw.

Hi everyone! im new to this forum and actually just created my account to post this question. Im replacing my front diff pinion seal on my 2004 wrangler tj with a dana 30. Upon removing the old seal, i cleaned up all the old oil and shined a light in there and noticed this gaping hole that does...

Trying to purchase my first wrangler for a relatively low price. I know rust is a problem on jeeps but I don't know how bad this one is. Was hoping you guys can tell me how bad and how to treat it.

I am completely lost for ideas. We have recently put in a new rear main seal and oil pan gasket while we had the tranny and tcase off. We started her up and were about to take her for a test drive when we noticed a pretty fast-ish leak dripping off the bottom on the bell housing.... and it would...

So, I'm not really looking to "rustproof" my car. I live in California so I don't really run into rust issues here. I have a good amount of surface rust and I just want to make it look nice (make it look back to its factory form). Can I use something like...

Hello all, I just got an 04 LJ with high miles, but one owner and it’s in very good condition with minimal rust. I’m a 20 year old kid who needs some help with upgrading. Im not gonna lie, I’m not going to take it off road nearly as much as I would like to, but I do not want a cheap setup that...

What’s up guys, new member here. I changed my heater core and now I have a no start issue, car does not crank. 2005 LJ unlimited I’ve ruled out the ign switch, neutral safety switch Starter my symptoms are, turn the key to the start position, cluster turns off, interior lights turn on no...

I bought fenders to upgrade and ran into trouble removing the old ones. How do I get the Screwserts out now that they are mended together from rust? I cut the fenders off to have better access but ended up stripping them, any suggestions?

When my tj was in the shop last it had the ac recharged and it was working good. Previously before that the ac clutch was changed because it was making an awful noice. Now my Ac blows straight hot air. I just did a new ac clutch relay hoping that would help but it still only now blows hot air...

Had a crazy whine in the rear end and with 160k plus miles I assumed it was due for bearings. When the ring and pinion came out it was obvious theY were shot along with the spider gears. Not planning a lift so my plan is to just replace the Dana 35-373 gears. When they showed up the ring gear is...

So I just bought my first Jeep! 2005 Wrangler SE 4.0 with 63k miles. Very exciting news BUT there are issues that need to be addressed before using it such as rear main seals, inner axle seals, front axel housing, and engine oil pan that contain leaks. It also needs an extension to the brake...

Hello! Purchased an 01' Sport a while back and hoping someone can help me identify the right soft top to fit to this existing hardware that came with it. It's unlike any soft top hardware I have ever seen. There were no door surrounds it looked like the soft top just hooked around the hardware...

Hey everyone, so I bought a 2002 Wrangler X about a month ago. And let’s just say it’s already been a ride. *pun intended*. The previous owner(s) did a bunch of stuff to it to make it look “nice” (some things I liked most I didn’t) but neglected to really take care of it. So far I’ve had to get...

Anybody know of the best or a easy way to make sure your intake manifold is aligned properly when putting it back on?

I have a 2000 Jeep Wrangler TJ, it is a 2.5 L 4 cylinder and I messed up. I went and bought a new exhaust manifold because my old one was cracked and it looked liked a straight foward thing. I took the fan, the fan cover, the power steering pump and belt, and went on with taking out the intake...

Is anyone in this area with Jeep expertise to come and help me look at a jeep? It's a 2004 Jeep Rubicon with 50k miles on it. He's asking 15k for it but it's always negotiable. He lives about 40 min away from Madera (in the hills he says). He doesn't want to have to take it down to a shop due to...

Alright i have a small issue if you could help me figure out the issue id appreciate it alot. I have a '98 wrangler se (auto 2.5) and when i put it in drive it tends to take off in 2nd. If i take off using the manual shift its fine. Fluid levels are fine no water in tranny. Any ideas what it...

hey everybody its time for me to get a new top for my jeep i currently have a soft top but i need to get a new one. I cant decide should i get a soft or a hard top? feel free to leave links to tops you recommend.

I’m having a problem with my 97 Jeep tj it sounds like it’s having a slight miss and whenever I go to accelerate it sounds rough until I get past first gear what could this be? I’m going to attach the video I took of me revving my engine and at idle I do have my exhaust cut off after the cat and...

Hello. I am from Phoenix AZ. New to the forum group. I have always wanted a Jeep but never pull the trigger, my brother owns a 2004 Sport that he is willing to sell. He lives in California and has never been off-road. Jeep is still 100% stock 200k miles. When I get it , what should I do...