Collector grade Jeep Wrangler TJs for sale

Picking up where I left off

Status
Not open for further replies.
NashvilleTJ said:
A long time ago when I was running a stock 42, I installed the Transgo kit. For me, the juice was definitely not worth the squeeze. I noticed almost no difference - perhaps the shifts were just a bit firmer - but it did nothing for the real problems with the 42.
Click to expand...
That's all you're going to get with a Stage 1 shift kit, but that's on purpose. It does reduce the overlap on the shifts a bit, which reduces heat and wear, but not so much that it bangs the shifts. In my youth, I went Stage 3 on a '68 Charger. It was hard not to chirp the 1-2 shift, and if I was on it, I had no problem barking the 2-3 shift as well as the 1-2. That was with a mildly warmed over 383.
 
  • Love
Reactions: Wildman
@mrblaine did it have vibes before the trans swap or is it a problem caused by the automatic transmission?

@Chris may be buying a hub kit half way back to AZ
 
For any of ya'll following along that think you can just fetch up seats off the internet and they will fit you, not so fast. The seats in his rig from the local company fit me very poorly. So poorly that if you brought them to me for free and told me I could run them, I would not. I'd find someone who likes to lean way back, likes to drive with their nuts cuddled by a banana bicycle seat, and likes to mash said nuts getting in and out and give the seats to them. But, for all I know, they may fit his very odd little body like a glove and be the very best thing since sliced bread.
 
  • Haha
Reactions: Fouledplugs, Vasq, taylormade73 and 11 others
Alex01 said:
@mrblaine did it have vibes before the trans swap or is it a problem caused by the automatic transmission?

@Chris may be buying a hub kit half way back to AZ
Click to expand...
Currently, it is vibe free up to 70 mph with the front driveshaft out. We don't chase our tails so we start with the rear and dial it in. We'll know more tomorrow.
 
  • Like
Reactions: Fouledplugs, Daryl, zebra12 and 2 others
mrblaine said:
Currently, it is vibe free up to 70 mph with the front driveshaft out. We don't chase our tails so we start with the rear and dial it in. We'll know more tomorrow.
Click to expand...
Well, at least @Chris will know that anything he does other than hubs after you're done will just mess it up. Mike told me the lengths you go to dialing it all in.
 
  • Like
Reactions: Chris
Status
Not open for further replies.

Similar threads

tworley
Tworley build
Replies
1,746
Views
255,907
TJ Build Threads & Member's Rides
mvigo
mvigo
erokj
Tasteful LJR Build
Replies
56
Views
9,871
TJ Build Threads & Member's Rides
erokj
erokj
Chris
  • Locked
A Simple Build
Replies
1,048
Views
127,675
TJ Build Threads & Member's Rides
Chris
Chris
Jaime313
Where do I start with this front end job?
Replies
14
Views
1,582
TJ General Discussion
Jaime313
Jaime313
G
Remaining Build Parts
Replies
0
Views
543
TJ General Discussion
GA05LJ
G
Jeep Wrangler TJ Performance PCM Tuning
Top Bottom
Back