I found them on an offroad for sale group via facebook.Where did you find the seats? Like an idiot I swapped out my driver’s seat for a Mastercraft Baja RS and am less than enthused about it......
I found them on an offroad for sale group via facebook.Where did you find the seats? Like an idiot I swapped out my driver’s seat for a Mastercraft Baja RS and am less than enthused about it......
If that's for sale let me knowI’ve been in need for months. Sick of hauling the spare in the tub. Someone local has a genright aluminum swing out for $800 but I’d rather spend $135
Mike is definitely getting better. I'd love to buy a welder and learn how to do it again but I just dont have the space or electrical to do itNice welds!
Everything attached to the spring pad is 3/16" thick. The control arm mounts are 1/4" thick. I'll have to modify the antirock links but thatll be easy. We'll definitely get it all cleaned up before the blasting.looks good. i like those nice thick sway brackets, might have to snag a pair of those.
take the flat end of a hardened file to that spatter, it'll chip it right away
Everything attached to the spring pad is 3/16" thick. The control arm mounts are 1/4" thick. I'll have to modify the antirock links but thatll be easy. We'll definitely get it all cleaned up before the blasting.
Yep. One of the reasons I went with Artec!Will those sway bar brackets allow for a tie rod flip?
Yep. One of the reasons I went with Artec!
those sway link brackets aren't 1/4"? they look thick.
Remind me where you found the tapered insert for the driver side knuckleI've got the reamer when you're ready.
My buddy sent me this, just a mockup
View attachment 127960
The plan is to burn everything on next weekend, then take it to the stripper/media blaster that same week. One step closer to the hpd30. The 5.13 regear should be complete by end of January I'm hoping
Will those sway bar brackets allow for a tie rod flip?
Yep. One of the reasons I went with Artec!
Interesting and good to know. Thanks for the heads up! I recall last year holding the perch up to another axle and it seemed like everything was in the same location but I could have overlooked it. Ill do some measuringDouble check that your steering clears those sway bar links and 1/4" thick trackbar mount. I previously had an axle with those brackets on them and they were all in the way of my Currie steering.
Do you have any pictures of that axle? Did you do the install? Im not near the build right now so Ill have to check it tomorrow when I go back to my welders shop. I have spare knuckles that I can toss on and do some rough mockups.Double check that... Artec says they fit, and they might with the stock steering linkages (which have no business being on a Jeep with these brackets), but in my experience they don't. I even shortened the control arms shorter than the jam nuts would allow and I still couldn't get the steering to clear.
Do you have any pictures of that axle? Did you do the install? Im not near the build right now so Ill have to check it tomorrow when I go back to my welders shop. I have spare knuckles that I can toss on and do some rough mockups.